by pmarklew » Tue Jul 26, 2011 1:31 am
Hi Larry
Many thanks for your reply. I now have 2 other questionsand would appreciate any response: -
1. Is it possible to pour a lure from the tail, over the wire. I ask this question because I want to pour some poppers with quite a cup face and I don't want any airlocks round the cup. So I thought I could pour face down and then hopefully if there were any airbubbles they would be no where near the cup.
2. Is it possible to mix two differing mixes of resin. Where I am going with this is, assuming I want to make a popper which I tail heavy, so it casts better and sits tail down in the water. Could I say, start pouring a resin mixed with microballoons until its say half full and then pour in the exact same type of resin mixed with a weighted solution. The resins are the same type. Would the resin bond as one or would it be weaker.
I realise I would have to work fast so that both mixes are poured straight after each other, no 5 minute break for example.
If any one else out there has an answe, I would love to hear. The poppers are going to be about 16cm long and quite slim.
Many thanks
Peter