by makeit urself » Mon Oct 10, 2011 11:16 am
i'm gonna share my gotcha plug how to with you since i couldn't find any info on how to make one, i used my own idea. first i took a 1 1/2", x 1 1/2",x 10" piece of wood, split it in half, then put 2 screws to pull it together again. then drilled a hole directly into the seam so it was perfectly round. the bit fit the diameter of the body i was useing which was a piece of aluminum arrow shaft cut down to 2 1/2- 3" in length. bent a wire (ss mig wire) to the shape i wanted and inserted it into the shaft and clamped it into the wood. poured the amount of lead i needed and cut off excess at 45 degree angle. its easier when you do it. i can send you pictures and better explanation if you contact me. i'm sure there is an easier way to do it with the LD products. its just too expensive for me. sorry larry..lol