Hello guys,
I want to make jigs like the ones I attached.
https://drive.google.com/open?id=0ByLyV ... VcxaHhFLTA
https://drive.google.com/open?id=0ByLyV ... Xg3R1BjeXc
I know that this may seem very simple to many of you, but I have NEVER dealt with mold making, or even mixing epoxy or anything like that in the past.
If you look at the jig, it has a wire going through it. Also has multiple hooks at the bottom. I do not need to cast these.
All i really need is to cast the BODY, not the wire, not the hooks.
Now here are my few questions:
1) What product can I use to cast this mold? I have seen a youtube video of Larry using RTV silicone. I liked that it was malleable. I figured I could poor my plastic/epoxy inside the mold and work it out?
2) If I chose to use a hard mold to have it for a longer period of time, what would I use then?
3)What kind of clear/see-through plastic/epoxy can I use to make this type of jig? I was thinking the kind of epoxy you would poor on top of a bar to keep it waterproof, but do you have a clear plastic that would work better?
I thinks that's it...
Any info would be really appreciated!