Tubes

Questions about Making Your Own Lures

Tubes

Postby bassfighter1 » Fri Aug 05, 2016 11:42 am

Hey Larry,I've Been Trying To Figure Out How To Make A Hollow Tube Bait,If I Need To Make A Two Piece Mold..And Have The Tinticles Strong Enough So They Wont Tear When I Remove The Lure From The Mold.
bassfighter1
 
Posts: 231
Joined: Thu Jan 27, 2011 9:57 am

Re: Tubes

Postby dahlberg » Fri Aug 05, 2016 12:00 pm

The best way I've seen is to make a cold metal mandril, or rod that's got the skirt grooves/ridges cut into it, then dipped into hardened Alumisol.
If you can find an axel the same diameter as the inside of the tube you are going to make with a spline cut the end of it to hold a gear or wheel,eit, it could be easily modified to work. Cut it ahead of the spline the length the tube body should be, round off a little, then beginning with a cold axel, dip it and let it cool for form as many layers as it takes to get the tube dia. you want. after it firms up just peel it off the tube and clean up the skirts.
Off the cuff, i'd say the other way is to use vac 50 and make a two piece injection mold.
good luck,
L
Larry Dahlberg
The Hunt For Big Fish
User avatar
dahlberg
Site Admin
 
Posts: 5279
Joined: Wed Oct 11, 2006 7:49 pm
Location: Taylors Falls, Minnesota


Return to Lure Making

Who is online

Users browsing this forum: No registered users and 32 guests