Page 1 of 1
Pressure
Posted:
Fri May 16, 2014 5:31 pm
by Marliner
What is a good pressure to use when using alumilite Clear?
Re: Pressure
Posted:
Sat May 17, 2014 10:11 pm
by aka anglinarcher
I cannot tell you the range, but the times I used it I did 60 PSI and it worked great. Never tried higher or lower so I cannot tell you for sure.
Re: Pressure
Posted:
Mon May 19, 2014 7:18 pm
by Mike - Alumilite
First, never use higher than the rating on your pressure pot!!!! Obvious ... I know but very dangerous if taken for granted. Second, make sure you have a properly working safety release valve that will pop before the rating on the tank is ever reached.
Now to the question ... 35-45 psi is typically enough pressure to make Alumilite Clear or Water Clear completely bubble free.
Mike
Re: Pressure
Posted:
Tue May 20, 2014 11:20 am
by Marliner
Thanks...my pot is rated at 80lbs and 35-45 sounds good and safe.