by Kitakis » Thu Mar 01, 2012 2:34 am
Craw trailer:I ran tiny wire (24 gauge) through the claws into the body , another at the tip of the claws to hold them together: that stiffened the claws enough to keep them straight.Then marked center line on mold box pieces allowing for half inch under and over part.At my center line i ran more wire through the mold box into the body and the claws.Poured HS2 up to claws.Next day used rubber 2 rubber release n poured 2nd half HS2.Every detail i was looking for is great.My shad also turned out excellent.I Couldn't have done this without adapting Larry's ideas to this application.Thank You Larry.I appreciate You and Mike passing on your Knowledge.Carol was very helpful too.I told carol i watched so many how to's Larry talks to me in my dreams.