Molding and pouring trolling heads
Posted: Tue Dec 27, 2011 8:41 pm
I want to make a silicone mold to pour the insert for a trolling head. I have some that I have turned and would like to mold the head and place the insert into place before pouring the clear. This knowledge is being held pretty close to the chest. I have been told that it is done with a single not a split mold and is poured vertically from the bottom of the lure facing up. Any help out there that you can share? I was also told that there are a couple of dvds on the subject but I haven't found them as of yet.