Videos

General Questions

Videos

Postby bassfighter1 » Wed Aug 02, 2017 12:00 pm

Hey Larry And Mike,Was Wondering When Were Any New Videos Were Coming Out And Larry Are Any New HFBF Episodes Going To Be Aired,Take Care Guys
bassfighter1
 
Posts: 205
Joined: Thu Jan 27, 2011 9:57 am

Re: Videos

Postby Mike - Alumilite » Tue Aug 15, 2017 12:21 pm

Sorry for the slow response to this as I know Larry and I have both been traveling quite a bit over the last couple months as well as trying to fish whenever we can.

Is there any specific videos that you anyone is looking for? Even if it is not a complete project but a process, product, or method of some sort. Our video library is fairly extensive and honestly I often get to the point of trying to think of new content.

So any help you can give us would be great.

thx,
Mike
Mike - Alumilite
 
Posts: 571
Joined: Sat Feb 28, 2009 8:15 pm
Location: Kalamazoo, MI

Re: Videos

Postby bassfighter1 » Thu Aug 17, 2017 12:13 pm

Hey Guys,I'm Trying To Figure Out How To Make A Line Thru Jointed Swimbait,I Really Don't Want To Use Eye Screws
bassfighter1
 
Posts: 205
Joined: Thu Jan 27, 2011 9:57 am

Re: Videos

Postby aka anglinarcher » Thu Aug 17, 2017 12:39 pm

Can you sketch out what you mean? I am not sure what you are talking about on a "LINE THRU". I am working on some different joint options and hope to give them to Mike for his review soon, so if I can understand the line thru requirements then I will try to incorporate it into the video.

I have an idea of what you are talking about, but there is enough room for confusion that I don't want to do the wrong one.
I think my bucket list has a hole in the bottom!
User avatar
aka anglinarcher
 
Posts: 796
Joined: Mon Jan 10, 2011 3:51 pm
Location: Northern Utah

Re: Videos

Postby bassfighter1 » Thu Aug 17, 2017 11:12 pm

Oops I Meant Wire Thru Swimbait,I Know To Form The Wire For The Line Tie And Hook Hanger But How Would I Go About Doing It For The Rear Section
bassfighter1
 
Posts: 205
Joined: Thu Jan 27, 2011 9:57 am

Re: Videos

Postby Mike - Alumilite » Fri Aug 18, 2017 5:45 am

I'd bend the wire for those separately and insert them into your mold, just as you do the head. The "joints" themselves can be done a few different ways such as with a pin.

Mike
Mike - Alumilite
 
Posts: 571
Joined: Sat Feb 28, 2009 8:15 pm
Location: Kalamazoo, MI


Return to General Questions

Who is online

Users browsing this forum: No registered users and 3 guests

cron